Changing a wash basin black mixer taps washer is a fairly straightforward process. The first step is to unplug the old one. Remove the retaining plate and the flexible tails from the wash basin. You can use an antibacterial cleaner to remove any muck and sealant. Then, clean the area around the hole of the tap, making sure that no water will leak. This step is also aesthetic.
Use a wash basin spanner
You will need a wash basin spanner to access the nut on the base of the tap. Make sure that you have a firm grip on the nut so you can turn it easily. If the nut is a tight fit, use easing fluid to loosen it. Then, position the spanner's jaws under the sink and wrap the tool around the backing nut. Once the retaining ring has come off, the faucet can be removed.
Before attempting to change a wash basin mixer tap washer, make sure to turn off the water supply and unplug the tap. A wrench is the best tool to use to loosen the valve. Once the valve is removed, the tap should also be removed. If the tap has a cover, you will need a flat-head screwdriver to remove it. Using a thick cloth will prevent any damage to your wash basin. Using a plug will prevent any components from falling down the pipe and damaging it.
It can be complicated
While changing the washer on a wash basin mixer tap may seem complicated, it is actually a relatively simple process. It will take you a few minutes and a few pence. To prevent the small parts from escaping and falling into the drain, plumbers recommend that you use a plastic backing nut instead of a metal one. The plastic backing nut can be replaced without the need to buy a new faucet.
Before you start changing a wash basin mixer tap washer, you should unplug it from the sink. Before you do this, you must make sure that you are aware of the safety instructions. If you are not familiar with these tips, you could end up damaging your sink mixer tap. The process of changing a wash basin mixer tap can be dangerous. Be sure that you use a socket wrench to avoid overtightening the valve.
Remove it
By following these steps, you can change the wash basin mixer tap washer. To remove the washer, you should unscrew the fixing studs from underneath the tap. Then, you can screw the washer back into place. Depending on the type of tap, you may need to buy a new retaining plate or replace the whole tap. You can also change the washer on the valve by following the instructions on the package.